PROFESSIONAL AUDIO EQUIPMENT PMX124 12 Channel mixing console User Manual & Installation GuideMixing Console PMX124 AUDAC
9 10. Main L/R master fader: This fader adjusts the final signal level sent to the ‘MAIN L/R’ output. 11. Level-Meter Signal Buttons: Use these but
1019. Phantom power switch: Use this switch to toggle the phantom power ON and OFF. When the switch is turned ON, the mixer supplies phantom power t
11Connections and Connectors Front panel connections 1. Channel input jacks: - MIC JACKS: 3-pin XLR connectors are used for the connection of bala
122. Channel insert I/O jack: These are ¼ " TRS (Tip, Ring, Sleeve) phone Jacks which support bi-directional operation. These input/output jac
139. ALT 3/4 output jacks: These are unbalanced ¼” phone type output jacks on which the output signal of the ALT 3/4 bus is available. These jacks
14Connections and Connectors Rear panel connections 1. AC adaptor in connector: Connects to the included PA-M1224 power adaptor. NOTE: Only use
15 Points to remember In all cases, always use high quality twin screened audio cable. Check for instability at the output. Always connect bot
17Applications Setup procedure 1. Before connecting the microphones and instruments, be sure that all devices are turned off. Also be sure that all
18Home Recording
AUDAC PROFESSIONAL AUDIO EQUIPMENT User Manual & Installation Guide AUDAC http://www.audac.eu [email protected]
19Live Performance
20Block Diagram Chapter 5
21Additional Information PMX124 Technical specifications 0 dB = 0.0775 Vrms, 0 dBV = 1 Vrms Chapter 6 Maximum Output L
22Input Input Connector Input Impedance Nominal Impedance Rated Input Level Connector Type CH Mic 4 k Ohm 50 ~ 600 Ohm -50 dB XLR 3-31 Type Ba
23Personal notes
2 INTRODUCTION ...
3 Introduction This section briefly describes the possibilities of the PMX124 Mixing Console. he PMX124 Mixing Console was developed as an easy to
4 Environment Do not place this unit in an enclosed environment such as a bookshelf or closet. Ensure that there is adequate ventilation to cool
5 Safety Requirements Always handle the unit with care. Only use a grounded socket outlet and a power cord with grounding plug to plug in the unit.
6 Front Panel Controls Channel Control Section 1. Peak LED indicator: These LED indicators light-up when the level of the input signal reaches 5 d
7 5. Aux controls: The Aux knobs controls the level of the signals that are sent to the Aux bus. 6. PRE / POST switch: This button determines whe
8 Main Control Section 1. DSP program display: This display shows the program number of the selected effects program. 2. DSP program select switc
Comments to this Manuals